Shredder operation manual: How to operate shredder machine daily
2021-07-01
Staurk Machinery
After bought a shredder from the shredder machine manufacturer, how to operate it？
Here is part of the operation manual we reorganized ,hope it can help you.
Here is part of the operation manual we reorganized ,hope it can help you.
1）Basic principles of operation:
The host must be started without load, no matter what the situation is.
2）System startup principle:
1 First peripheral equipment and then main equipment;
2. First auxiliary equipment and then processing equipment.
3）Boot steps:
a) First start the switch of the electric control cabinet,
b) then run the machine without load for one minute to check that the machine is normal,
c) and finally start feeding.
b) then run the machine without load for one minute to check that the machine is normal,
c) and finally start feeding.
4）production process control:
1. According to the current of the main motor, gradually increase the feeding until the current of the main motor reaches and stabilizes at 85%-95% of the rated value;
2. Pay attention to the current changes at any time during the crushing process, and adjust the feeding amount in time to ensure the best load;
3. During the operation, the warehouse patrolman checks the particle size of the crushed materials at any time, and if there is an abnormality, the machine will be shut down for inspection;
4. When the equipment is running, it is strictly forbidden to climb on the body of the equipment;
5）work after shutdown:
1. After stopping, check the shredder and solve the problem in time;
2 Do a good job in the cleaning of the equipment and the sanitation of the surrounding environment;
3. Pack up tools and materials, and store them at designated locations;
4. Fill in the shredding work record carefully.
6）What to do if it stops suddenly ？
6）What to do if it stops suddenly ？
a)Be sure to cut off the power first to avoid other problems
b)At the discharge port, check whether there is material blockage: it is necessary to avoid overload operation.
c)If there is a blockage, clean it up in time.
d)Check the voltage, it cannot be used when it is too low.
e)Check the parts of the equipment frequently, take a look at the elasticity of the V-belt, the wear of the bearings and tools, whether the line is damaged, etc.